Manufactured Home Electrical- Half of Doublewide without power

Double and triple wide mobile homes have a single main panel from where electrical power is distributed. The electrical power to the section(s) without the main panel is concentrated in one or a few points at the marriage line where the parts of th...

28/02/2008 | Print | PDF

Manufactured Home Furnaces- Troubleshooting

Pilot won't stay lit. Hold down the button, light, hold for a minute, let up. If the pilot goes out, it's the thermocouple. This is a $7 part. Pilot stays on but the furnace doesn't come on, step 1. Do you hear a click when you raise th...

28/02/2008 | Print | PDF

Manufactured Home Flooring- Soft Spots

Less common in newer homes that have plywood or OSB (Oriented Strand Board) subfloors. A big problem in homes with particle board floors. It results when the subfloor gets wet and the sub fl...

28/02/2008 | Print | PDF

Manufactured Home Tools-Carpet

Modern carpet is designed to be stretched 1 to 1 1/2 %. Thus if your home is 16' wide the carpet should be stretched about 2". This can not be done accurately with a kicker. Carpet manufacturers are constantly searching for ways to produce car...

28/02/2008 | Print | PDF

Manufactured Home Tools-Drywall

Manufactured home drywall is is the same as any drywall except for concerns about weight. However, the weight concerns are no minor matter. With Manufactured homes you MUST ALWAYS remember they were carefully engineered to meet the requirements but...

28/02/2008 | Print | PDF

Manufactured Home Tools

Pliers, screwdrivers etc. are used on many types of projects. Fish Tape. This is a reel of strong, flexible wire that is used to pull new or replacement electrical wire through the walls. If you are dealing with a mobile home with wood paneled wa...

28/02/2008 | Print | PDF

Manufactured Home Doors-Exterior

Manufactured home exterior doors are made like a sandwich with a metal or vinyl sheet on the outside, a Styrofoam core and a metal or vinyl sheet on the inside. They are sized by what the industry calls hole size. By that they mean that if you take...

28/02/2008 | Print | PDF

Manufactured Home Countertops-Chipped or Burned

If the countertop has a large burned or damaged area, then there is a good chance it is located in a position where it is convenient to set down a pot or pan. If this is the case you might consider routing out an area of the countertop and installi...

28/02/2008 | Print | PDF

Manufactured Home Countertops-Sagging

A sagging countertop has probably been damaged by water. In many kitchen counters the faucet was brought up through the counter material itself and when the faucet washers or O rings fail water leaks under the laminate and the particle board fails....

28/02/2008 | Print | PDF

Manufactured Home Countertops-Cracked Ceramic

If you need to replace a cracked ceramic tile and have or can buy one that matches, the procedure is as follows. Use a grout saw to remove the grout around all four sides of the damaged tile. If the edge of the tile is loose you may be able to pry ...

28/02/2008 | Print | PDF